GC Fabrications Front Strut Tower Brace For Mazda MX-5 NA NB

1 Review

£80.00

Clear selection
19 users have this item in wishlist
Compare

Suitable for an NA car, not suitable for a VVT swapped NA car.

All GCFabrications braces are made from high quality steel (45mm diameter with a 2mm side wall) and finished in durable satin black powder coat.

These strut braces are a very popular tuning part for road use and an essential for track use, they are the cheapest way to improve the suspension and handling of the car.

By strengthening the front suspension turrets, the suspension geometry is kept stable by reducing the movement of the inner wings, increasing road holding and reducing tyre wear.

• INCREASED ROAD HOLDING
• LESS CHASSIS FLEX
• REDUCED TYRE WEAR

Supplied with all stainless steel fittings

This item will fit all engine variants.

Stiffen your suspension and improve your cars handling with a strut brace fitted.

Weight N/A
Dimensions N/A
Brand

GC Fabrications

Model

NA NB (Non-VVT), NB2 (VVT)

1 review for GC Fabrications Front Strut Tower Brace For Mazda MX-5 NA NB

  1. CJ Hubbard (verified owner)

    Excellent bit of kit, this. I know they don’t do much on MX-5s but I’ve always been of the opinion that every little helps – and this brace has a lot of things going for it.

    Firstly, it’s a single piece, so no pivot points to reduce its effectiveness.

    Secondly, although it’s made of high strength steel, it weighs barely more than my old lightweight aluminium Carbing bar.

    Thirdly, and most importantly for me, the design is angled back much closer to the firewall than any other brace of this type I’ve seen – and this means it comfortably clears the offset Jenvey ITB pod filter. Hurrah.

    I also think it’s quite clever in the way it handles forces – the bar joins the plates at a point that’s actually folded back over the end of the strut towers, rather than on the flat portion surrounding the top mount. Have no technical knowledge to back this up, but suspect this makes it stronger.

    The only way it could be better would be if it had a brake master cylinder built-in.

Add a review
You have to agree to the comment policy.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Make Model Year
Mazda MX-5 1989 - 2005

We Can Install This For You

Alongside part sales, we also operate a workshop service to install and configure all the products we offer online.

For the past decade, we’ve been servicing, modifying and boosting our own MX-5s. What started as three guys in a shed has grown into a workshop full to the brim of MX-5 knowledge and passion, where no project is too big or service job too small.

If you’d like to book something in or have a chat about your build, give us a call on +44 (0) 203 795 0515 or send us an email at [email protected]